![]() ![]() Make sure it is in good condition and fastened securely to the tractor. Check the tractor master shield over the PTO stub shaft. Once engaged and ready to start cutting, raise PTO speed to 540 rpm and maintain throughout cutting operation.ĥ. When engaging PTO, the engine rpm should always be low. Know how to stop the tractor and mower quickly in case of an emergency.Ĥ. Refer to your tractor manual for PTO engagement and disengagement instructions. Mower operating power is supplied from tractor PTO. Be sure the tractor is in “Neutral” before starting engine.ģ. Be sure that no one is near the machine prior to engaging or while the machine is working.Ģ. Ensure that all safety shielding and safety signs are properly installed and in good condition.ġ. Ensure mower is properly mounted, adjusted and in good operating condition.Ĩ. Operate only in daylight or good artificial light.ħ. Clear area to be cut of stones, branches or other debris that might be thrown, causing injury or damage.Ħ. Serious injury or even death could result from falling off the tractor.ĥ. Operate the mower only with a tractor equipped with an approved Personal protection equipment including hard hat, safety glasses, safety shoes, and gloves are recommended during assembly, installation, operation, adjustment, maintaining and/or repairing the implement.Ĥ. wires, bands, and tape have been removed.ģ. Thoroughly inspect the implement before initial operation to assure that all packaging materials, i.e. Before operating equipment read and understand the operator’s manual and the safety signs (see fig. It is the mower owner’s responsibility, if this machine is used by any person other than yourself, is loaned or rented, to make certain that the operator, prior to operating, reads and understands the operator’s manuals and is instructed in safe and proper use.ġ. Read this manual, and the manual for your tractor, before assembly or operation, to acquaint yourself with the machines. Working with unfamiliar equipment can lead to careless injuries. It is the operator’s responsibility to read and understand all safety and operating instructions in the manual and to follow these.Īllow only properly trained personnel to operate the mower. In addition to the design and configuration of equipment, hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training of personnel involved in the operation, transport, maintenance and storage of equipment. Unfortunately our efforts to provide safe equipment can be wiped out by a single careless act of an operator. ![]() Safety is the primary concern in the design and manufacture of our products. Only these approved replacement parts should be used. Your Authorized Company Dealer has genuine parts in stock. Carefully read the warranty statement on the back of your original purchase order for details on coverage and limitations of this warranty. Warranty coverage is provided by John Deere according to the terms of the Agricultural/Commercial & Consumer Equipment Warranty Statement. Other tools that do not fit properly can slip and cause injury.ĬAUTION: Right hand and left hand sides of the implement are determined by facing in the direction the implement will travel when going forward (see fig. Use only metric tools on metric hardware. Serious damage can occur to the machine and/or the operator.ĬAUTION: Unless otherwise specified, all hardware is metric. Do not operate this implement at a PTO speed or direction of rotation other than that shown on the implement. ![]() The implement described in this manual is to be used with tractors with PTO at 540 rpm and clockwise rotation.ĬAUTION: Always ensure that the coupling of the implement with the tractor is done at the same PTO speed and direction of rotation. Failure to do so could result in personal injury and/or in equipment damage. It will instruct you on how to operate and service your mower safely and correctly. Your new Flex Wing grooming mower is a technologically advanced machine constructed of high quality, sturdy components that will fulfill your working expectations. Thank you and congratulations for having chosen our implement. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |